310011 G16NE 1/6
WAFELMAKER
*310.011
WAFFLE MAKER
310011 G16NE 2/6
KEN UW WAFELMAKER
de roestvrijstalen ‘Waffle Maker’ maakt heerlijke wafels. De machine is gemaakt met een
satijnafwerking, hoogwaardig roestvrijstaal en elke plaat is gecoat met twee lagen non-stick
materiaal. De kookplaten kunnen afzonderlijk worden ingeschakeld voor meer zuinigheid.
OPERATING INSTRUCTIONS
1. Before use remove screws on handle and clamp and t plastic handle over clamp and
screw on tightly.
2. Both sets of plates can be switched independently.
3. Pre-heat Wafe Plates for 8 minutes.
4. Very lightly oil the top and bottom wafe plates before using for the rst time. Thereafter
it is only necessary to smear a little oil after making a few wafes. DO NOT OVER OIL,
as this will cause staining of the exterior surfaces.
5. Pour one large tablespoon of the mixture in the middle of the grid.
6. Close the lid and allow to cook for a couple of minutes.
7. Lift the lid and remove the wafe with plastic tongs or spatula NEVER USE METAL
UTENSILS.
8. It is imperative that the wafe plates are wiped over with a damp cloth after each use to
prevent carbon build up.
9. After each day’s use, allow to cool. Use a NYLON BRUSH and clean ALL signs of
grease off the plates and then Wipe over with a clean damp cloth.
10. Never immerse the wafe iron in water.
11. Shut off power when not in use and disconnect from wall socket.
CLEANING
DAILY CLEANING
Ensure that the wafe maker is disconnected from the electricity supply before attempting any
cleaning. Use a damp cloth and clean thoroughly.
IF CARBON HAS BUILT UP
A damp BRILLO pad can be used to remove carbon build up. Ensure that all traces of the
cleaning agent are removed before toasting. Lightly oil the plates for a few uses after
cleaning.
IT IS IMPERATIVE THAT THE CLEANING INSTRUCTIONS ARE
COMPLIED WITH.
GUARANTEE
In the unlikly event of a fault with your Dualit wafe maker, providing it is within one year from
date of purchase, please contact the place of purchase or Dualit direct. Keep your receipt safe,
as you will require this as proof of purchace.
AAN/UIT-SCHAKELAAR
VOETEN
HANDGREEP
WAFELPLAATEN
310011 G16NE 3/6
KNOW YOUR WAFFLE MAKER
The hardworking stainless steel ‘Waffle Maker’ make delicious waffles. The machine is made
from satin finish, top grade stainless steel and each plate is coated with two layers of
Non-stick material. The Hotplates can be turned on individually for greater economy.
GEBRUIKSAANWIJZING
1. Voor gebruik, verwijder de schroeven van de handgreep en de klem en plaats de plastic
handgreep over de klem en schroef deze stevig vast.
2. Beide sets platen kunnen onafhankelijk van elkaar worden geschakeld.
3. Verwarm de wafelplaten 8 minuten voor.
4. Vet voor het eerste gebruik de bovenste en onderste wafelplaten heel licht in.
Daarna is het alleen nodig om na het maken van een paar wafels de platen een beetje in te
vetten. GEBRUIK NIET TE VEEL VET, omdat dit vlekken op de buitenoppervlakken
veroorzaakt.
5. Giet een grote eetlepel van het beslagmengsel in het midden van het rooster.
6. Sluit het deksel en laat een paar minuten bakken.
7. Til het deksel op en verwijder de wafel met een plastic tang of spatel. GEBRUIK NOOIT
METALEN GEREEDSCHAP/VOORWERPEN.
8. Het is absoluut noodzakelijk dat de wafelplaten na elk gebruik met een vochtige doek
worden afgeveegd om afzetting van verbrandingsresten te voorkomen.
9. Na gebruik laten afkoelen. Gebruik een NYLON BORSTEL om ALLE vet resten van de
platen te verwijder en veeg het vervolgens af met een schone, vochtige doek.
10. Dompel het wafelijzer nooit onder in water.
11. Schakel de stroom uit wanneer deze niet in gebruik is en haal de stekker uit het
stopcontact.
REINIGING
DAGELIJKSE SCHOONMAAK
Zorg ervoor dat het wafelijzer is losgekoppeld van het elektriciteitsnet voordat u gaat
schoonmaken. Gebruik een vochtige doek en maak grondig schoon.
ALS KOOLSTOF (VERBRANDINGSRESTEN) IS OPGEBOUWD
Een vochtige BRILLO pad kan worden gebruikt om koolstofophoping te verwijderen. Zorg
ervoor dat alle sporen van het reinigingsmiddel zijn verwijderd voordat u gaat bakken.
Vet de platen na het schoonmaken licht in voor een volgend gebruik.
HET IS VERPLICHT OM DE REINIGINGSINSTRUCTIES UIT TE VOEREN.
POWER SWITCH
FEET
HANDLE
WAFFLE PLATES
310011 G16NE 4/6
Instruction Manual & Guarantee
*310.011
WAFFLE MAKER
310011 G16NE 5/6
KNOW YOUR WAFFLE MAKER
The hardworking stainless steel ‘Wafe Maker’ make delicious wafes. The machine is made
from satin nish, top grade stainless steel and each plate is coated with two layers of
Non-stick material. The Hotplates can be turned on individually for greater economy.
OPERATING INSTRUCTIONS
1. Before use remove screws on handle and clamp and t plastic handle over clamp and
screw on tightly.
2. Both sets of plates can be switched independently.
3. Pre-heat Wafe Plates for 8 minutes.
4. Very lightly oil the top and bottom wafe plates before using for the rst time. Thereafter
it is only necessary to smear a little oil after making a few wafes. DO NOT OVER OIL,
as this will cause staining of the exterior surfaces.
5. Pour one large tablespoon of the mixture in the middle of the grid.
6. Close the lid and allow to cook for a couple of minutes.
7. Lift the lid and remove the wafe with plastic tongs or spatula NEVER USE METAL
UTENSILS.
8. It is imperative that the wafe plates are wiped over with a damp cloth after each use to
prevent carbon build up.
9. After each day’s use, allow to cool. Use a NYLON BRUSH and clean ALL signs of
grease off the plates and then Wipe over with a clean damp cloth.
10. Never immerse the wafe iron in water.
11. Shut off power when not in use and disconnect from wall socket.
CLEANING
DAILY CLEANING
Ensure that the wafe maker is disconnected from the electricity supply before attempting any
cleaning. Use a damp cloth and clean thoroughly.
IF CARBON HAS BUILT UP
A damp BRILLO pad can be used to remove carbon build up. Ensure that all traces of the
cleaning agent are removed before toasting. Lightly oil the plates for a few uses after
cleaning.
IT IS IMPERATIVE THAT THE CLEANING INSTRUCTIONS ARE
COMPLIED WITH.
GUARANTEE
In the unlikly event of a fault with your Dualit wafe maker, providing it is within one year from
date of purchase, please contact the place of purchase or Dualit direct. Keep your receipt safe,
as you will require this as proof of purchace.
POWER SWITCH
FEET
HANDLE
WAFFLE PLATES
310011 G16NE 6/6
KNOW YOUR WAFFLE MAKER
The hardworking stainless steel ‘Wafe Maker’ make delicious wafes. The machine is made
from satin nish, top grade stainless steel and each plate is coated with two layers of
Non-stick material. The Hotplates can be turned on individually for greater economy.
OPERATING INSTRUCTIONS
1. Before use remove screws on handle and clamp and t plastic handle over clamp and
screw on tightly.
2. Both sets of plates can be switched independently.
3. Pre-heat Wafe Plates for 8 minutes.
4. Very lightly oil the top and bottom wafe plates before using for the rst time. Thereafter
it is only necessary to smear a little oil after making a few wafes. DO NOT OVER OIL,
as this will cause staining of the exterior surfaces.
5. Pour one large tablespoon of the mixture in the middle of the grid.
6. Close the lid and allow to cook for a couple of minutes.
7. Lift the lid and remove the wafe with plastic tongs or spatula NEVER USE METAL
UTENSILS.
8. It is imperative that the wafe plates are wiped over with a damp cloth after each use to
prevent carbon build up.
9. After each day’s use, allow to cool. Use a NYLON BRUSH and clean ALL signs of
grease off the plates and then Wipe over with a clean damp cloth.
10. Never immerse the wafe iron in water.
11. Shut off power when not in use and disconnect from wall socket.
CLEANING
DAILY CLEANING
Ensure that the wafe maker is disconnected from the electricity supply before attempting any
cleaning. Use a damp cloth and clean thoroughly.
IF CARBON HAS BUILT UP
A damp BRILLO pad can be used to remove carbon build up. Ensure that all traces of the
cleaning agent are removed before toasting. Lightly oil the plates for a few uses after
cleaning.
IT IS IMPERATIVE THAT THE CLEANING INSTRUCTIONS ARE
COMPLIED WITH.
POWER SWITCH
FEET
HANDLE
WAFFLE PLATES
-
1
-
2
-
3
-
4
-
5
-
6
