537005 en ma 2012 2
1. BASIC PARAMETER
Model PC-G1500
Dimensions 520x380x670mm
Power 220~240V / 50~60Hz
Consumption 1500W
Effi ciency 3~5Min / Plate
Temperature Range 220°C~260°C
2. TRANSPORTATION AND STORAGE
As all four corners of this machine are made of toughened glass, still be very careful when
handling, never put it in upside down position nor shake it violently. Store in a warehouse
where is draught and away from corrosive gas. Do not place in open air, but if necessary,
please make sure it is not reached by rain or sunshine.
3. SAFETY PRECAUTIONS
A The machine should be placed on a stable and upright position away from rain
or sunshine.
B The supplied voltage must coordinate with the one indicated on the parameter.
The margin should be at +-10%.
C A proper power switch, fuse, and protecting switch should be installed near
the machine. Do not place any object in front of the switch for more convenient
operation.
D Grounding wire and power cable are from the same line, therefore should be
plugged to a three-phase inlet according to safety standards.
E Warning: Do not pour water in the popcorn bowl while its working for it may
cause serious damages.
4. INSTRUCTIONS
A Press the heat preservation and lighting switch for the tube and bulb to start working.
B Press the rotating and heating button. After 5-7 mins. of preheating, place 1 piece
of popcorn with 5g of oil on the plate, if the corn pops, the preparation is done.
C Begin with pouring 50ml of oil in the bowl, then 150g of corn and 100g of sugar for
popping. You can hardly hear any popping noises after about 5 minutes, then open
the cover and get it out.
D Please do not move your attention away while is popping. Close the glass door to
prevent corn from dropping out of the case. Stir the bowl until it has fi nished popping.
E Prevent oil from dripping on the plate for it will dirty it and may cause burning during
pre-heat.