Extreme Networks Environmental Sensor Module Installatie gids

Type
Installatie gids

Deze handleiding is ook geschikt voor

Introduction
The MOD-8XXX-0001E-WW sensor module is a USB environmental sensor
extension to the AP-8132 model Access Point. It provides a wireless sensing
mechanisms for ambient lighting conditions, allowing monitoring and reporting
within the AP-8132's radio coverage area. The output of the sensor's detection
mechanisms are reported and viewable within the software architecture.
Document Conventions
The following graphical alerts are used in this document to indicate notable
situations:
NOTE Tips, hints, or special requirements that you should take note of.
CAUTION Care is required. Disregarding a caution can result in data
loss or equipment malfunction.
WARNING! Indicates a condition or procedure that could result in
personal injury or equipment damage.
Warnings
• Read all installation instructions and site survey reports, and verify correct
equipment installation before connecting the MOD-8XXX-0001E-WW
environmental sensor module.
•Remove jewelry and watches before installing this equipment.
•Verify any device connected to this unit is properly wired and grounded.
•Verify there is adequate ventilation around the device, and that ambient
temperatures meet equipment operation specifications.
Precautions
Before installing a MOD-8XXX-0001E-WW, verify the following:
•Do not install the MOD-8XXX-6001S-WW in wet or dusty areas.
Verify the environment has a continuous temperature range between -20°C to
75°C
.
Specifications
Length 2.5 in /6.3 cm
Width 6.0 in / 15.24 cm
Height 2.0 in / 4.127 cm
Weight 0.270 lb / 0.123 kg
Operating Temperature -20
° to 75° celsius / -4° to 167° farenheit
Storage Temperature -40
° to 70° celsius / -40° to 185° farenheit
The MOD-8XXX-0001E-WW environmental sensor module is plenum rated.
CAUTION To maintain the plenum rating, the MOD-8XXX-0001E-WW
must be directly attached to the Access Point. Do no install the sensor
module using the optional mounting hardware or an extension cable.
Zebra Technologies Corporation.
Lincolnshire, IL 60069 USA
MOD-8XXX-0001E-WW Environmental Sensor Module
Installation Guide
MN001389A01
Revision B April 2015
(2)
(1)
(3) (4) (5) (6)
Installing the MOD-8XXX-0001E-WW on an AP-8132 Access Point
CAUTION Power off the Access Point prior to installing the
MOD-8XXX-0001E-WW.
No tools are required to install the sensor module. The tabs on the top and
bottom of the module snap into the corresponding slots on the Access Point.
1. Align the tabs on the MOD-8XXX-0001E-WW with the corresponding slots on
the Access Point.
2. Securely attach the MOD-8XXX-0001E-WW to the Access Point. The module
can be attached to either side of the Access Point.
3. Confirm the MOD-8XXX-0001E-WW is operational by observing its LED.
To remove the MOD-8XXX-0001E-WW, depress the tabs on the top and
bottom of the sensor module and carefully detach it from the Access Point.
Installing the MOD-8XXX-0001E-WW Using the Mounting Hardware
1. Attach the mounting bracket at the desired location using wall anchors and
1/8 inch x 1 1/2 inch screws (customer supplied).
2. Align the tabs on the MOD-8XXX-0001E-WW with the corresponding slots on
the mounting bracket and securely attach the sensor module.
3. Connect the MOD-8XXX-0001E-WW to the Access Point using a USB
extension cable (customer supplied).
4. Confirm the sensor module is operational by observing its LED.
Regulatory Information
This guide applies to Model Number KHUSBMAAT.
All Zebra devices are designed to be compliant with rules and regulations in
locations where they are sold and will be labeled as required.
Any changes or modifications to Zebra equipment, not expressly approved by Zebra,
could void the user's authority to operate the equipment.
Radio Frequency Interference Requirements - FCC
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help.
Marking and European Economic Area (EEA)
Statement of Compliance
Zebra hereby declares that this device is in compliance with all the applicable
Directives, 2004/108/EC and 2006/95/EC. A Declaration of Conformity may be
obtained from:www.zebra.com/doc.
Waste Electrical and Electronic Equipment (WEEE)
English: For EU Customers: All products at the end of their life must be returned to
Zebra for recycling. For information on how to return product, please go to:
www.zebra.com/weee
.
Français: Clients de l'Union Européenne: Tous les produits en fin de cycle de vie
doivent être retournés à Zebra pour recyclage. Pour de plus amples informations sur le
retour de produits, consultez : www.zebra.com/weee
.
Español: Para clientes en la Unión Europea: todos los productos deberán entregarse a
Zebra al final de su ciclo de vida para que sean reciclados. Si desea más información
sobre cómo devolver un producto, visite: www.zebra.com/weee
Български: За клиенти от ЕС: След края на полезния им живот всички продукти
трябва да се връщат на Zebra за рециклиране. За информация относно
връщането на продукти, моля отидете на адрес: www.zebra.com/weee
.
Deutsch: Für Kunden innerhalb der EU: Alle Produkte müssen am Ende ihrer
Lebensdauer zum Recycling an Zebra zurückgesandt werden. Informationen zur
Rücksendung von Produkten finden Sie unter www.zebra.com/weee
.
Italiano: per i clienti dell'UE: tutti i prodotti che sono giunti al termine del rispettivo ciclo
di vita devono essere restituiti a Zebra al fine di consentirne il riciclaggio. Per
informazioni sulle modalità di restituzione, visitare il seguente sito Web:
www.zebra.com/weee
.
Português: Para clientes da UE: todos os produtos no fim de vida devem ser
devolvidos à Zebra para reciclagem. Para obter informações sobre como devolver o
produto, visite: www.zebra.com/weee
.
Nederlands: Voor klanten in de EU: alle producten dienen aan het einde van hun
levensduur naar Zebra te worden teruggezonden voor recycling. Raadpleeg
www.zebra.com/weee
voor meer informatie over het terugzenden van producten.
Polski: Klienci z obszaru Unii Europejskiej: Produkty wycofane z eksploatacji nale¿y
zwróciæ do firmy Zebra w celu ich utylizacji. Informacje na temat zwrotu produktów
znajduj¹ siê na stronie internetowej www.zebra.com/weee
.
Tested to Comply
With FCC Standards
For Home or Office Use
Symbol Technologies Inc.
(8) (10) (12) (14)
(7) (9) (11) (13)
Čeština: Pro zákazníky z EU: Všechny produkty je nutné po skonèení jejich životnosti
vrátit spoleènosti Zebra k recyklaci. Informace o zpùsobu vrácení produktu najdete na
webové stránce: www.zebra.com/weee
.
Eesti: EL klientidele: kõik tooted tuleb nende eluea lõppedes tagastada taaskasutamise
eesmärgil Zebra'ile. Lisainformatsiooni saamiseks toote tagastamise kohta külastage
palun aadressi: www.zebra.com/weee
.
Magyar: Az EU-ban vásárlóknak: Minden tönkrement terméket a Zebra vállalathoz kell
eljuttatni újrahasznosítás céljából. A termék visszajuttatásának módjával kapcsolatos
tudnivalókért látogasson el a www.zebra.com/weee
weboldalra.
Svenska: För kunder inom EU: Alla produkter som uppnått sin livslängd måste
returneras till Zebra för återvinning. Information om hur du returnerar produkten finns
www.zebra.com/weee
.
Suomi: Asiakkaat Euroopan unionin alueella: Kaikki tuotteet on palautettava
kierrätettäväksi Zebra-yhtiöön, kun tuotetta ei enää käytetä. Lisätietoja tuotteen
palauttamisesta on osoitteessa www.zebra.com/weee
.
Dansk: Til kunder i EU: Alle produkter skal returneres til Zebra til recirkulering, når de er
udtjent. Læs oplysningerne om returnering af produkter på: www.zebra.com/weee
.
Ελληνικά: Για πελάτες στην Ε.Ε.: Όλα τα προϊόντα, στο τέλος της διάρκειας ζωής τους,
πρέπει να επιστρέφονται στην Zebra για ανακύκλωση. Για περισσότερες πληροφορίες
σχετικά με την επιστροφή ενός προϊόντος, επισκεφθείτε τη διεύθυνση
www.zebra.com/weee
στο ∆ιαδίκτυο.
Malti: Għal klijenti fl-UE: il-prodotti kollha li jkunu waslu fl-aħħar tal-ħajja ta' l-użu
tagħhom, iridu jiġu rritornati għand Zebra għar-riċiklaġġ. Għal aktar tagħrif dwar kif
għandek tirritorna l-prodott, jekk jogħġbok żur: www.zebra.com/weee
.
Românesc: Pentru clienţii din UE: Toate produsele, la sfârşitul duratei lor de
funcţionare, trebuie returnate la Zebra pentru reciclare. Pentru informaţii despre
returnarea produsului, accesaţi: www.zebra.com/weee
.
Slovenski: Za kupce v EU: vsi izdelki se morajo po poteku življenjske dobe vrniti
podjetju Zebra za reciklažo. Za informacije o vračilu izdelka obiščite:
www.zebra.com/weee
.
Slovenčina: Pre zákazníkov z krajín EU: Všetky výrobky musia byť po uplynutí doby ich
životnosti vrátené spoločnosti Zebra na recykláciu. Bližšie informácie o vrátení výrobkov
nájdete na: www.zebra.com/weee
.
Lietuvių: ES vartotojams: visi gaminiai, pasibaigus jų eksploatacijos laikui, turi būti
grąžinti utilizuoti į kompaniją „Zebra“. Daugiau informacijos, kaip grąžinti gaminį, rasite:
www.zebra.com/weee
.
Latviešu: ES klientiem: visi produkti pēc to kalpošanas mūža beigām ir jānogādā
atpakaļ Zebra otrreizējai pārstrādei. Lai iegūtu informāciju par produktu nogādāšanu
Zebra, lūdzu, skatiet: www.zebra.com/weee
.
Türkçe: AB Müşterileri için: Kullanım süresi dolan tüm ürünler geri dönüştürme için
Zebra'ya iade edilmelidir. Ürünlerin nasıl iade edileceği hakkında bilgi için lütfen şu
adresi ziyaret edin: www.zebra.com/weee
.
Turkish WEEE Statement of Compliance
EEE Yönetmeliğine Uygundur
Japan (VCCI) - Voluntary Control Council for Interference
Class B ITE
Korea Warning Statement for Class B ITE
China
Taiwan
Thailand
Support
If you have a problem with your equipment, contact support for your region. Contact
information is available at: www.zebra.com/support
. When contacting support, please
provide the following information:
Serial number of the unit
Model number or product name
Software type and version number
Support responds to calls by e-mail, telephone, or fax within the time limits set forth in
support agreements. If you purchased your product from a business partner, contact
that business partner for support.
Customer Support Web Sites
Support, located at www.zebra.com/support
, provides information and online
assistance including developer tools, software downloads, product manuals and online
repair requests.
Manuals
www.zebra.com/support
.
Copyright
Zebra and the Zebra head graphic are registered trademarks of ZIH Corp. The
Symbol logo is a registered trademark of Symbol Technologies, Inc., a Zebra
Technologies company.
© 2015 Symbol Technologies, Inc.
  • Page 1 1
  • Page 2 2

Extreme Networks Environmental Sensor Module Installatie gids

Type
Installatie gids
Deze handleiding is ook geschikt voor