COLORdash S-Par 1 QRG EN
2
Guide
The COLORdash S-Par 1 Quick Reference Guide (QRG) has basic product
information such as connection, mounting, menu options, and DMX values.
Download the User Manual from www.chauvetprofessional.com for more details.
The information and specifications contained in this QRG are subject to change
without notice.
• DO NOT open this product. It contains no user-serviceable parts.
• To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
• DO NOT look at the light source when the product is on.
• CAUTION: This product’s housing may be hot when lights are operating.
• Mount this product in a location with adequate ventilation, at least
20 in (50 cm) from adjacent surfaces.
• DO NOT leave any flammable material within 50 cm of this product while
operating or connected to power.
• CAUTION: When transferring product from extreme temperature
environments, (e.g. cold truck to warm humid ballroom) condensation may
form on the internal electronics of the product. To avoid causing a failure,
allow product to fully acclimate to the surrounding environment before
connecting it to power.
• Not for permanent outdoor installation in locations with extreme
environmental conditions. This includes, but is not limited to:
o Exposure to a marine/saline environment (within 3 miles of a
saltwater body of water).
o Where the normal high or low temperatures of the location
exceed the temperature ranges in this manual.
o Locations that are prone to flooding or being buried in snow.
o Other areas where the product will be subject to extreme
radiation or caustic substances.
• USE a safety cable when mounting this product overhead.
• DO NOT submerge this product (IP65). Temporary outdoor operation is
fine.
• When using this product in an outdoor environment, use IP65 (or higher)
rated power and data cables. Be sure to secure unused power and data ports
with attached IP65 covers.
• DO NOT operate this product if the housing, lenses, or cables appear
damaged.
• DO NOT connect this product to a dimmer or rheostat.
• ONLY connect this product to a grounded and protected circuit.
• ONLY use the hanging/mounting bracket to carry this product.
• In the event of a serious operating problem, stop using immediately.
• The maximum ambient temperature is 113 °F (45 °C). Do not operate this
product at higher temperatures.
Outside the U.S., United Kingdom, Ireland, Mexico, or Benelux, contact your
distributor to request support or return a product. From inside the U.S., UK,
Ireland, Mexico, or Benelux, use the information in Contact Us at the e
Included
• Seetronic Powerkon
• Warranty Card