70-906

QTY

DESCRIPTION MFG. PART NO.KEY NO.

1

2

3

4

5A

6

2

2

22

4

P70-906-1

P70-906-2

P70-906-3

P70-906-4

P70-105-63

P70-105-62

70-906M4

RIKON Power Tools, Inc.

Billerica, MA. 01821

877-884-5167

www.rikontools.com

Tools Required for Assembly

that is set onto the top of the bed casting.

Align the bed rails (Left or Right) by using a straight edge inside the bed channel.Align the bed rails (Left or Right) by using a straight edge inside the bed channel. This ensures that the tailstock

will float freely without jamming. Tighten the two bolts after the bed extension is level and in line with the lathe.

NOTE: The 70-105 Bed Extension is supplied with rubber feet for use on a bench. To permanently mount the

lathe and extension on a bench, use the mounting holes in the bases. Remove the rubber feet and insert 1” to

1-1/4” thick spacers (the rubber feet or washers, bushings, wood strips) under the casting when screwing or

bolting the machine down (mounting hardware is not provided). bolting the machine down (mounting hardware is not provided). NOTE: The lathe’s TEFC motor requires 1” extra

space below the bed to allow airflow and room to pivot the motor down for belt changes.

For mounting on a stand, the spacers may not be needed if the lathe’s motor can swing free below the bed

casting when mounted on the stand plate.