* Before assembling the unit, please confirm that all parts listed below are included
in the package.
● Right-side speaker attachment (x 1) ● Fixing screws (M5 x 4)
● Left-side speaker attachment (x 1)
SPAT1
* Firmly tighten each of the
attachment parts and screws.
Printed in Indonesia
* Specifications are subject to change without notice.
YAMAHA Speaker Attachment
■ SPAT1 Set up example
Thank you for purchasing the Yamaha SPAT1 Electronic Drum Speaker Attachment.
Before using the attachments, we ask that you thoroughly read this Owner’s Manual to use
the product in a safe manner.
● Assembly Instructions
(this sheet)
■ SPAT1 Package Contents
PRECAUTIONS
Before using, please read this “Assembly Instruction” sheet,
and use this product in a safe and proper manner.
Especially for children, parents or an instructor should teach
the children the proper manner in which to use the device.
To prevent against accidents and injury
Please follow the cautions listed below
Caution (including danger, or warning).
This mark indicates cautions in which you should
pay close attention to.
Acts indicated with this icon are prohibited and should
not be attempted.
This icon indicates acts that you are urged to follow.
Use the supplied screws when attaching the
attachments to the speaker.
The speaker falling off may result in injury.
This attachment is designed for attaching a pair
of speakers to an electronic drum system rack.
Do not use this product for any other purpose.
Do not attach any speakers other than those
specified for use with the product.
Speakers can become damaged or fall off
resulting in injury.
Watch your fingers when adjusting the clamp.
Fingers can become pinched and injured.
Take care around the end of, and inside the pipe.
Sharp objects, etc. can result in injured fingers, etc.
Use the supplied band to secure the cables,
etc. Tripping over cables can cause the unit to
fall over, drop off, etc. and also result in injury.
If this symbol is ignored and the equip-
ment is used improperly, fatal injury to
persons or serious damage could occur.
A Phillips (+) screwdriver is required when attaching the SPAT1 module.
■ SPAT1 Dimensions
100
2–ø6
60
56
Unit: mm
Speaker
Screws
Right-side
speaker
attachment
Left-side
speaker
attachment
Firmly insert the
pipe end fully into
the clamp.
OWNER’S MANUAL
CAUTION
Firmly tighten the fixing screws.
Parts may drop or fall off, etc., which can result
in injury.
Do not suddenly loosen screws or bolts when
adjusting the height or angle. It may cause the
speaker to slide down or fall off resulting in
injuries such as pinched hands or fingers, etc.
After assembly and attachment is complete,
make sure the attachments are safe and secure.
Also, check regularly to make sure that the
attachments are safe and secure so as to prevent
the product from falling off or dropping.
If this symbol is ignored and the equip-
ment is used improperly, there is a danger
of injury to persons handling the equip-
ment, and material damage could occur.
WARNING
Speaker Compatibility
These attachments are compatible with the following Yamaha
speakers, etc.
● MSP3*
● MS101
II
● MS202II
* When connecting the audio source to the MSP3, use the MSP3’s RCA
input jacks. Connecting the audio source to the phone jack will not
produce sufficient volume output.
Do not use the attachment with any speaker that weighs over 5.0kg.