• Before carrying out any operation make sure that
the appliance is disconnected from the power
supply.
• Make sure that the parameters on the rating plate
are compatible with the electrical ratings of the
mains power supply.
• Make sure the appliance is installed correctly. Loose
and incorrect electricity mains cable or plug (if
applicable) can make the terminal become too hot.
• Use the correct electricity mains cable.
• Do not let the electricity mains cable tangle.
• Make sure that a shock protection is installed.
• Use the strain relief clamp on the cable.
• Make sure the mains cable or plug (if applicable)
does not touch the hot appliance or hot cookware,
when you connect the appliance to the near
sockets.
• Do not use multi-plug adapters and extension
cables.
• Make sure not to cause damage to the mains plug
(if applicable) or to the mains cable. Contact our
Authorised Service Centre or an electrician to
change a damaged mains cable.
• The shock protection of live and insulated parts
must be fastened in such a way that it cannot be
removed without tools.
• Connect the mains plug to the mains socket only at
the end of the installation. Make sure that there is
access to the mains plug after the installation.
• If the mains socket is loose, do not connect the
mains plug.
• Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
• Use only correct isolation devices: line protecting
cut-outs, fuses (screw type fuses removed from the
holder), earth leakage trips and contactors.
• The electrical installation must have an isolation
device which lets you disconnect the appliance from
the mains at all poles. The isolation device must
have a contact opening width of minimum 3 mm.
Use
Warning! Risk of injury, burns and
electric shock.
• Remove all the packaging, labelling and protective
film (if applicable) before first use.
• This appliance is for household use only.
• Do not change the specification of this appliance.
• Make sure that the ventilation openings are not
blocked.
• Do not let the appliance stay unattended during
operation.
• Set the cooking zone to “off” after each use.
• Do not rely on the pan detector.
• Do not put cutlery or saucepan lids on the cooking
zones. They can become hot.
• Do not operate the appliance with wet hands or
when it has contact with water.
• Do not use the appliance as a work surface or as a
storage surface.
• If the surface of the appliance is cracked, disconnect
immediately the appliance from the power supply.
This to prevent an electrical shock.
• Users with a pacemaker must keep a distance of
minimum 30 cm from the induction cooking zones
when the appliance is in operation.
• When you place food into hot oil, it may splash.
Warning! Risk of fire and explosion
• Fats and oil when heated can release flammable
vapours. Keep flames or heated objects away from
fats and oils when you cook with them.
• The vapours that very hot oil releases can cause
spontaneous combustion.
• Used oil, that can contain food remnants, can cause
fire at a lower temperature than oil used for the first
time.
• Do not put flammable products or items that are wet
with flammable products in, near or on the
appliance.
Warning! Risk of damage to the
appliance.
• Do not keep hot cookware on the control panel.
• Do not put a hot pan cover on the glass surface of
the hob.
• Do not let cookware to boil dry.
• Be careful not to let objects or cookware fall on the
appliance. The surface can be damaged.
• Do not activate the cooking zones with empty
cookware or without cookware.
• Do not put aluminium foil on the appliance.
• Cookware made of cast iron, aluminium or with a
damaged bottom can cause scratches on the glass /
glass ceramic. Always lift these objects up when you
have to move them on the cooking surface.
• This appliance is for cooking purposes only. It must
not be used for other purposes, for example room
heating.
Care and cleaning
• Clean the appliance regularly to prevent the
deterioration of the surface material.
• Deactivate the appliance and let it cool down before
you clean it.
• Disconnect the appliance from the electrical supply
before maintenance.
18