In Lite Hub100 de handleiding

Type
de handleiding

Deze handleiding is ook geschikt voor

www.in-lite.com
HUB-50
HUB-100
INSTALLATION MANUAL
12V / 50VA & 100VA
NL | Gebruik dit product alleen binnen het in-lite systeem. Wanneer in
het systeem componenten worden gebruikt die niet van in-lite afkomstig
zijn, vervalt het recht op garantie | Monteer de componenten van het
in-lite systeem (armaturen, transformators, mini-connectors, Easy-Locks
en kabelverbinders) zodanig dat zij altijd vervangen kunnen worden |
Gebruik de in-lite laagspanningskabel nooit in combinatie met 100-240V.
Deze is alleen geschikt voor het gebruik in combinatie met de onderdelen
van het in-lite 12 volt laagspanningssysteem.
EN | This product may only be used within the in-lite system. If
components are used in the system that do not originate from in-lite, the
warranty no longer applies | Install the in-lite system components
(fixtures, transformers, mini-connectors, Easy-Locks and cable
connectors) so that they can easily be replaced | Never use the in-lite
low-voltage cable in combination with 100-240V. This is only suitable for
use with the components of the in-lite 12 volt low-voltage system.
DE | Verwenden Sie dieses Produkt nur in einem in-lite-System. Wenn im
System Komponenten verwendet werden, die nicht von in-lite stammen,
verfällt der Garantieanspruch | Montieren Sie die Komponenten des
in-lite-Systems so (Lampen, Transformatoren, Mini-Verbinder, Easy-Locks
und Kabelverbinder) so, dass sie jederzeit ersetzt werden können |
Verwenden Sie das in-lite Niederspannungskabel nicht in Kombination
mit 100-240V. Es ist nur für die Verwendung in Kombination mit Teilen des
in-lite-12-Volt-Niederspannungssystems geeignet.
NO | Dette produktet må bare brukes i forbindelse med in-lite systemet.
Hvis det benyttes komponenter i systemet som ikke kommer fra in-lite,
forfaller retten til garanti | Monter komponentene i in-lite systemet
(lamper, transformatorer, minikontakter, Easy-Lock og kabelskjøtere) slik
at de alltid kan skiftes | Lavspenningskabelen fra in-lite må aldri brukes
til 100-240 V. Den er kun egnet til bruk sammen med delene fra in-lite 12
volt lavspenningssystem.
SE | Använd bara denna produkt i kombination med in-lite-systemet | Om
komponenter används i systemet som inte kommer från in-lite, förfaller
garantin |Montera alltid komponenterna i in-lite-systemet (armaturer,
transformatorer, mini-connectors, Easy-Locks och kabelkopplingar) så att
man lätt kan komma åt dem |Använd aldrig lågspänningskabeln i
kombination med 100-240 V | Den är endast lämplig för användning i
kombination med ett lågspänningssystem på 12 V.
FR Utilisez ce produit uniquement au sein du système in-lite. Lorsque des
composants non d’origine in-lite sont utilisés dans le système, tout droit à
garantie devient caduc | Montez les composants du système in-lite
(armatures, transformateurs, mini-connecteurs, systèmes Easy-Lock et
raccords de câble) de manière à ce qu’ils puissent toujours être remplacés |
N’utilisez jamais le câble basse tension in-lite en combinaison avec le
100-240 V. Celui-ci convient uniquement pour l’utilisation en combinaison
avec les composants du système basse tension 12 volts in-lite.
2x
1x 2x
2x
1x
www.in-lite.com
2
3 4
5 6
7 8
9 10
50mm
end of 12V
14/2 cable
end of 12V
10/2 cable
o14mm for
light sensor
2x cable entrance.
You can use one or
both entrances.
Maximum load on one
or both entrances is
always the maximum
load of the HUB.
entrance for MOVE
motion detector
8mm
12V CABLE
outdoor situation
50cm
indoor situation
1
www.in-lite.com
11 12
13 14
15 16
!!Short Circuit
Lights go out because
of short circuit.
Find and solve the
problem. Press power
button when solved.
Lights will go on.
Overload
Lights are still on
but too much fixtures
are installed on the
tranformer.
Remove fixtures
to solve overload.
warning sign 1 warning sign 2
1
3
9
1
2
3
48 6
10
12
minute
m tion
n
TOUCHSCREEN
BUTTONS
PRESS FOR NEXT
FUNCTION
OFF AND CURRENT
FUNCTION BLINK 1 TIME
PER SECOND
TRANSFORMER
FUNCTIONS
1
3
9
1
2
3
48 6
10
12
minute
m tion
n
TURN ON
WHEN INSTALLING
LIGHTS
1
3
9
1
2
3
486
10
12
minute
m tion
n
OFF BLINKS 2 TIME PER
SECOND AND CURRENT
FUNCTION IS OFF
1
3
9
1
2
3
48 6
10
12
minute
m tion
n
Automatic ON
Automatic OFF
Automatic ON
Automatic OFF after
X
hours
Always OFF
Motion
Detection
see manual
‘MOVE’
Always ON
1
3
9
1
2
3
48 6
10
12
minute
m tion
n
  • Page 1 1
  • Page 2 2
  • Page 3 3

In Lite Hub100 de handleiding

Type
de handleiding
Deze handleiding is ook geschikt voor

Gerelateerde artikelen