5019 318 33065
AKR 997
PRODUCT SHEET
To clean the grease filter
Wash the grease filter once a month, or whenever the
grease filter saturation indicator flashes (Extraction
speed indicator 2).
1. Disconnect the electrical power supply.
2. Remove the grease filters: push the handles back
(a), and then downwards (b).
3. After cleaning the grease filter refit in reverse
order, making sure the entire extraction surface
is covered.
Resetting the grease filter saturation indicator:
press the extractor OFF button for three seconds. The
grease filter saturation indicator will stop flashing.
Replacing bulbs
1. Disconnect the electrical power supply.
2. Unscrew the lighting unit (c).
3. Remove the burnt-out bulb.
Replace with 20 W max. halogen bulbs only.
4. Screw the lighting unit back in place.
Fitting or renewing the carbon filter
1. Disconnect the electrical power supply.
2. Remove the grease filters.
3. If the carbon filters are already mounted (two
filters covering the motor protection grille) and
need renewing, turn the central handle
anticlockwise until the filters release.
4. If the filters are not already fitted, locate one on
each side to cover both motor protection grilles,
then turn the central filter handle clockwise.
5. Replace the grease filters.
CONTROL PANEL
1. Speed decrease button - 5
Ö
1.
2. Extraction OFF button.
3. Extraction ON speed increase button - 0
Ö
5.
4. Extraction speed indicator 1.
5. Extraction speed indicator 2 and grease filter
saturation indicator (when flashing).
6. Extraction speed indicator 3.
7. Extraction speed indicator 4.
8. Extraction speed indicator 5.
9. Intensive extraction speed indicator.
10. Timed intensive speed button.
The hood operates at this speed for 5 minutes
and then returns to the previous settings.
This function can be cancelled by pressing button
1, 2 or 3.
11. Light ON-OFF switch.
1. Control panel.
2. Grease filters.
3. Grease filter handles.
4. Halogen bulb.
5. Telescopic flue.
D F NL E
GB
P I GR
31833065.fm Page 6 Wednesday, December 11, 2002 10:56 AM