01/2007
13
7.2 Special cleaning every two weeks
If the cavity is not be kept free from fur, the
coffeemaker will not percolate well, resulting in
weak and luke warm coffee. For a proper use
the following instructions has to be carried
out.
1. If the coffeemaker is used daily, the cavity
must be cleaned every two weeks with a
coffee fur remover. For this, switched the
coffeemaker off and remove the plug from
the socket.
2. Allow the reservoir to drain untill no more
water comes out of the tap and let the
percolator cool off.
3. After cleaning, the cavity has to be rinsed
several times with warm water, and
drained off.
7.3 Descaling
During use - depending on the hardness of
the water -, the cavity of the coffeemaker can
be furred up. For energy saving and fault
free functioning, the coffeemaker has to be
cleaned regulary with a scale remover.
1. Make a solution of a scale remover ( see
instructions on the packaging ).
2. Insert the percolator pipe through the
center of the grate and place it in the
reservoir. Make sure that the foot of the
percolator pipe is positioned firmly on the
cavity of the base.
3. Pour 1 Litre of the scale solution in the
reservoir, place the top lid on the reservoir
and switch the coffeemaker on.
The solution will now flush throught the
system.
4. Leave the coffeemaker switched on for
15 minutes.
5. Switch the coffeemaker off and tap off the
acid solution completely.
6. Rinse the inside of the reservoir and the
parts thoroughly with hot water.
7. The coffeemaker is now ready to use.
7. MAINTENANCE
7.1 Normal cleaning after use
• Clean the filter basket, filter basket lid
and the top lid with a non-abrasive
detergent and then dry them off with a soft
dry cloth.
• The outside of the coffeemaker can be
cleaned with a soft damp cloth and then
dried off with a soft dry cloth. Do not use
any abrasives as these can cause
scratches and mat spots.
• The inside of the reservoir and the
percolator pipe can be cleaned with a
coffee fur remover.
• For cleaning of the tap, remove the upper
assembly from the tap and clean the tap
with the brush through the tapconnection
at the innerside of the coffeemaker. For
the upper assembly, make a solution of
coffee fur remover and let the part soak
for 15 - 30 minutes.
WARNING
- Stay near the machine while maintenance
is being carried out.
- When descaling, always follow the
instructions of the descaling agent used.
- It is advisable to wear protecting glasses
and gloves during descaling.
- Allow the machine to run through at least
three times to rinse the solution from the
system after it has been descaled.
- Wash your hands thoroughly after
descaling
- The appliance should not be submerged
or hosed off.
- Make sure all the repairs to the appliance
are carried out by a qualified technician.
!