Documenttranscriptie

SAFETY SAFETY PRECAUTIONS PRECAUTIONS DEFINITION The instructions to be followed are classified by the following symbols: This symbol denotes an action that is PROHIBITED. These symbols denote actions that are COMPULSORY. To prevent personal injury, injury to others, or property damage, please observe the following. Incorrect operation due to failure to follow instructions may cause harm or damage, the seriousness of which is classified as below: This sign warns of Caution injury or damage to property. Warning This sign warns of death or serious injury. Remote Control • Do not use rechargeable (Ni-Cd) batteries. • Do not allow infants and small children to play with the remote control to prevent them from accidentally swallowing the batteries. • Remove the batteries if the unit is not going to be used for a long period of time. • New batteries of the same type must be inserted following the polarity stated to prevent malfunction of the remote control. Indoor Unit • Do not install, remove and reinstall the unit by yourself; improper installation will cause leakage, electric shock or fire. Please consult an authorized dealer or specialist for the installation work. • Do not insert your fingers or other objects into the unit. • Do not attempt to repair the unit by yourself. Indoor Unit • Do not install the unit in a potentially explosive atmosphere. • Do not wash the unit with water, benzene, thinner or scouring powder. • Do not use for other purposes such as preservation of food. • Do not use any combustible equipment in front of the airflow outlet. • Do not expose directly to cold air for a long period. • Ensure that the drainage pipe is connected properly. Otherwise, leakage may occur. • Aerate the room regularly. Power Supply Power Supply • Do not share the same power outlet with other equipment. • Do not modify power cords. • Do not use extension cords. • Do not operate with wet hands. • Use the specified supply cord. • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • This equipment must be earthed and strongly recommended to be installed with Earth Leakage Circuit Breaker (ELCB) or Residual Current Device (RCD). Otherwise, it may cause electrical shock or fire in case of malfunction. • In case of emergency or abnormal conditions (burnt smell, etc), turn off the power supply, and consult your nearest dealer. 2 Outdoor Unit • Do not insert your fingers or other objects into the unit, sharp parts may cause injury. Air inlet Air inlet Air outlet • Switch off the power supply before cleaning or servicing. • Turn off the power supply if the unit is not used for a long period of time. • This air conditioner is equipped with a built-in surge protective device. However, in order to further protect your air conditioner from being damaged by abnormally strong lightning activity, you may want to disconnect it from the power supply. Do not touch the air conditioner during lightning, it may cause electric shock. Outdoor Unit • Do not sit or step on the unit, you may fall down accidentally. • Do not touch the sharp aluminum fin, sharp parts may cause injury. • Ensure that the drainage pipe is connected properly. Otherwise, leakage may occur. • After long periods of use, make sure the installation rack is not damaged.   • To turn ON or OFF the unit at a preset time. ON • For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. TO ACHIEVE TEMPERATURE QUICKLY QUIET TO ENJOY QUIET ENVIRONMENT POWERFUL TIMER 1 2 • This operation reduces airflow noise. SET OFF Select ON or OFF timer. QUIET ENGLISH TO SET THE TIMER TO SELECT FAN SPEED (5 OPTIONS) Set the time. • To cancel ON or OFF timer, press Confirm. ON or OFF then press CANCEL . • When ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time. QUIET • and can be activated in all modes and can be cancelled by pressing the respective button again. • and same time. QUIET Notes: • For Hide-Away models, can not be selected at the • Timer operation is based on the clock set in the remote control and repeats daily once set. For clock setting, please refer to Remote Control Preparation at back cover. • If timer is cancelled manually or due to power failure, you can restore the previous setting (once power is SET . resumed) by pressing AUTO AIR SWING buttons are not in use. OPTIONAL SETTINGS MANUAL • Airflow direction can not be adjusted. CLOCK RESET Press and hold for approximately 10 seconds to show 12-hour (am/pm) or 24-hour time indication. Press to restore the remote control’s default setting. Set the temperature 1°C higher in cool mode or 2°C lower in heat mode than the desired temperature to achieve a 10% power saving. Use curtains to screen off sunlight and outdoor heat to reduce power consumption during cool mode. 7  POUR SÉLECTIONNER LA VITESSE DU VENTILATEUR (5 OPTIONS) POUR RÉGLER L’HEURE • Pour mettre l’appareil sous ou hors tension à une heure prédéfinie. POUR ATTEINDRE RAPIDEMENT LA TEMPÉRATURE SOUHAITÉE TIMER 1 SET OFF POWERFUL POUR UN ENVIRONNEMENT SILENCIEUX • Cette opération réduit le bruit du flux d’air. QUIET QUIET Sélectionnez le Réglez l’heure. Confirmez. mode marche (ON) ou arrêt de la minuterie (OFF). • Pour annuler le mode marche (ON) ou arrêt de la ON minuterie (OFF), appuyez sur ou sur OFF , puis sur CANCEL . • Lorsque le mode minuterie est activé, il se peut que l’appareil démarre avant l’heure réelle définie de façon à atteindre la température que vous avez choisie (environ 35 minutes avant). QUIET • Les fonctions et peuvent être activées dans tous les modes et peuvent être annulées en appuyant à nouveau sur la touche correspondante. • L’opération de minuterie se base sur le réglage de l’horloge de la télécommande et se répète quotidiennement une fois définie. Pour régler l’horloge, veuillez consulter la Préparation de la télécommande sur le couvercle arrière. QUIET et ne peuvent pas • Les fonctions être sélectionnées en même temps. Remarque: • Pour les modèles Hide-Away, les touches inutiles. 2 FRANÇAIS ON • Pour AUTO, la vitesse du ventilateur intérieur est automatiquement ajustée en fonction du mode de fonctionnement. • Si la minuterie est annulée manuellement ou par une panne de courant, vous pouvez restaurer le réglage antérieur (une SET fois le courant rétabli) en appuyant sur . AUTO AIR SWING sont RÉGLAGES FACULTATIFS MANUAL • Impossible d’ajuster la direction du flux d’air. CLOCK RESET Maintenez la touche enfoncée pendant environ 10 secondes pour passer du mode d’affichage de l’heure 12 h (am/pm) ou au mode 24 heures et inversement. Appuyez pour revenir aux réglages par défaut de la télécommande. Augmentez de 1°C la température souhaitée en mode de refroidissement ou diminuez de 2°C la température souhaitée en mode de chauffage pour atteindre une économie d’énergie de 10%. Utilisez des rideaux pour faire barrage à la lumière du soleil et à la chaleur extérieure pour réduire la consommation d’énergie en mode de refroidissement. 15