Spangenberg International B.V. – Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
First Time Use
• Unpack and inspect your machine immediately after receipt. If there are any latent defects or damage to
the machine then immediately contact your supplier. Save all packaging materials in case the machine
needs to be returned or inspected by the freight carrier.
• Remove any protective film from all surfaces (if applicable).
• Read this instruction manual completely before attempting to install and operate this product. When in
doubt, contact your supplier.
• If your machine is supplied with a factory fitted molded plug then you may plug the unit into a standard
electrical outlet. Make sure that the voltage of the machine and the wall outlet are compatible. If your
machine is not supplied with a factory fitted molded plug then a qualified electrical engineer must be
contracted to wire the unit to the power supply.
• Before using the appliance for the first time, it is recommended to clean the appliance according to
instructions (see chapter “Cleaning and Maintenance”).
Installation
1. The machine must be positioned on a flat and stable surface.
2. Choose a surface where the machine is not exposed to direct sunlight, or close to a direct source of heat
such as a cooker, oven or radiator.
3. When positioning the appliance, maintain a distance of 10cm (4 inches) between the appliance and walls or
other objects for ventilation and ease of use.
4. Position the machine in such a way that the plug is accessible at all times.
5. Install the required parts & accessories (if applicable).
6. Plug the power plug into a grounded and compatible socket.
Operation
• Switch on the appliance using the “ON/OFF” switch located at the front.
• Select the desired temperature using the temperature control dial.
• Allow the appliance to reach the selected temperature (do not close lid during pre-heating). The orange
indicator will switch of when selected temperature has been reached.
• Add batter to the Waffle Maker by gently pouring it in the middle of the bottom plate. Make sure to cover
the entire bottom grid with batter (when using the Lollipop Waffle Maker, place a heat resistant stick in the
designated recess prior to adding the batter).
• Close the lid and set the timer as needed, using the timer control dial located at the front.
• Regularly rotate the cooking plates to ensure even cooking (Maxima Bubble Waffle Maker only).
• Once the timer is finished it will make a “ding” sound. Open the cooking plates and check your product. If
cooked satisfactory, remove the waffle(s) using a pair of tongs, do not use your hands.